Water Injection

Here are some quick pics I snapped of my H2O Injection Kit install on my MR2 Turbo.

These pictures were snapped using my camcorder and Thinkpad 770 laptop, which yielded 640x480 bmps, so obviously, the quality is somewhat lacking... sorry.

• 1. Water Tank (2.5 gallon rubbermaid gas cannister)
• 2. Water Tank, and 1/4" inside diameter rubber grommet allows water tube and pressure sensor wires into the engine bay
• 3. same as #2
• 4. Water Pump (race pump) and inline filter under the carpet in trunk - passenger side, under the power antenna
• 5. Water pump relay (to the left of the PCME)
• 6. Close-up of water jet (on IC to TB pipe) - note the silicon hose over the water tubing (any place the hose might touch something hot)
• 7. Wider view of water jet
• 8. View of water jet from rear of car
• 9. Another close up of water jet
• 10.The pressure sensor for the pump is in there... to the left of the oil filler tank
• 11.Another not very good pic of the pressure sensor.